A voter finds their street split between districts and asks what is gerrymandering. It is drawing district lines intentionally to advantage one group or party over another, as a UCLA definitions page puts it.
The practice sits at the end of a longer chain, from the census count to House seat totals to the maps themselves. That chain is the thread of this guide, and wider coverage lives in us news today.
What gerrymandering is, and what it is not
Gerrymandering is defined by purpose. A map is gerrymandered when its lines are intentionally manipulated to benefit one group or party, according to the UCLA definitions. A map that merely happens to favour someone has not met that test.
The word is older than most of the rules around it. The Campaign Legal Center traces it to 1812, when Massachusetts approved a state Senate map with a salamander-shaped district that benefited the governor’s own party. The governor was Elbridge Gerry.
Cracking and packing
Map drawers rely on two opposite moves, both described by the Brennan Center.
- Cracking: splits groups of disfavoured voters among multiple districts, so no single district gives them enough weight to win.
- Packing: crams members of disfavoured groups or parties into as few districts as possible, which concentrates their votes in a handful of seats.
Both moves sacrifice some voters’ influence to protect the drawer’s side elsewhere. A street split between districts, as in the opening, is the kind of outcome cracking produces.
Apportionment is not redistricting
A common mix-up treats the two as one step. They are separate stages with different actors and outputs. Apportionment decides how many seats each state holds. Redistricting decides where the lines inside a state fall.
| Feature | Apportionment (reapportionment) | Redistricting | Planning use |
|---|---|---|---|
| What it does | Reassigns representation based on population | Sets new district lines after reapportionment is complete | Ask which stage a news story is describing before judging it. |
| What it produces | A seat count for each state out of 435 House seats | Districts with roughly equal numbers of constituents | Seat totals are not the place to look for line manipulation. |
| Where manipulation can enter | Population-based, so little room for it | Line placement, through cracking and packing | Gerrymandering concerns belong to this second stage. |
Definitions come from UCLA’s redistricting glossary, and the seat and district-size details from the Bipartisan Policy Center.
From census count to House seats
The pipeline starts with population. The Campaign Legal Center explains that census data is used to apportion the 435 congressional seats across all 50 states. The Bipartisan Policy Center describes the same step as population-based reapportionment of the 435 House seats among states.
A state that grows faster than others can gain seats, and a state that grows slowly can lose them. The census does not draw a single district line. It only sets the number of districts each state must create.

Who draws the lines inside each state
Once seat totals are set, each state must redraw boundaries to create districts with roughly equal numbers of constituents, per the Bipartisan Policy Center. In most states the legislature is responsible for drawing both congressional and legislative district lines.
That arrangement explains why the process is so contested. The people who benefit from a map are often the people who vote on it. Hearings and committee votes are where maps are proposed, amended and approved, so they are the best places to watch for the choices that matter.

Courts and Section 2 at the map-drawing stage
Courts shape what map drawers can and cannot do, but the two main routes work very differently.
Rucho v. Common Cause (2019)
In 2019 the Supreme Court held in Rucho v. Common Cause that claims of partisan gerrymandering present political questions beyond the reach of federal courts, as the Bipartisan Policy Center summarises. The Brennan Center notes the Court called gerrymandering “inconsistent with democratic principles” yet still put it outside federal court review. The post-2020 cycle was the first since that ruling, so partisan maps could not be challenged in federal court.
The practical result is that a voter who objects to a partisan map cannot rely on a federal partisan-gerrymandering claim. Political and procedural remedies matter more, including the commission models covered below.
Section 2 of the Voting Rights Act
Section 2 is a separate tool. As amended by Congress in 1982, it bans election systems or policies that intentionally restrict voting, and it also reaches discriminatory results, according to the Campaign Legal Center. Section 2 therefore speaks to the effect of a map, not just the motive behind it.
The standard is also moving. The same source reports that an April 2026 Supreme Court ruling in Louisiana v. Callais significantly altered the burden for proving Section 2 claims. Anyone following a current map dispute should check how that ruling applies before assuming older Section 2 reasoning still holds. For the voting-rules side of this law, see voter id laws by state.

Independent commissions and other models
Handing lines to legislators is not the only design. The Bipartisan Policy Center reports that a growing number of states have adopted independent commissions that exclude current officeholders. A single national total is not given there, and states keep changing their systems, so check a state’s current rules before relying on any count.
- Independent commissions: citizen bodies that keep current officeholders out of the drawing room.
- Hybrid systems: New York and Virginia share responsibility between a commission and the legislature.
- Advisory commissions: Iowa and Maine use independent advisory commissions that help draft maps, with the legislature still approving them.
The hybrid and advisory models keep elected officials in the loop, so they reduce but do not remove legislative influence. A fully independent commission is the model that most clearly separates mapmaking from officeholders. Public meetings are how residents can weigh in under any of these designs.
Reading a map dispute
Three questions sort most redistricting stories. First, is the claim about seat counts (apportionment) or line placement (redistricting)? Second, who drew the map: a legislature, a commission, or a hybrid? Third, which legal route is in play: a partisan claim barred from federal court, or a Section 2 claim under a recently changed standard? These same House seats are on the ballot in what are midterm elections, which is where map decisions show up in results.

Frequently asked questions
| Question | Answer |
|---|---|
| Where does the word gerrymandering come from? | It comes from Elbridge Gerry, the governor who approved an 1812 Massachusetts state Senate map with a salamander-shaped district that benefited his own party, according to the Campaign Legal Center. |
| How often does the census happen? | The Constitution requires one every 10 years, in years ending in zero, and its population data feeds apportionment, per the Campaign Legal Center. |
| Are congressional and state legislative districts held to the same population standard? | No. Congressional districts face stricter population equality requirements than state legislative or local districts, according to the Campaign Legal Center. The equal-population rule for legislative districts traces to a 1964 ruling, Reynolds v. Sims, per the Bipartisan Policy Center. |
| Can a state redraw its map before the next census? | Yes. Texas redistricted in 2003 even after its legislature had enacted a map following the 2000 census, as the Bipartisan Policy Center notes. |



